Next: Project Build
Up: Project Surface
Previous: Reflecting Time-Dependent Data
The surface data of the geometries is stored in Geom2d instances
therefore it is possible to select whether the surface, its boundary curves
or parameter lines should be displayed (by setting or deleting the correct
bits in the Geom2d flags, compare 6.3.4). This is what the
second row of the Surface user-interface shown in figure 8.16 is used for:
-
- This checkbox selects if the Geom2d surfaces
should be shown. Each geometry has its own instances with their own flags
therefore the selection has to be done for each geometry separately.
-
- Selects whether the boundary should be drawn. Some rulers
will be added if this checkbox is on, they allow to control the
discretization and the radius of the tube drawn around the boundary lines.
- ,
- Same for the horizontal and vertical parameter
lines. The lines might not be available, for example when they were not
computed for the original object before it was reflected and merged or
closed.
SFB 256 Universität Bonn and IAM Universität Freiburg Copyright © by the Sonderforschungsbereich 256 at the Institut für Angewandte Mathematik,
Universität Bonn.